Welcome to our website中文网站

NEWS

The process flow of automatic vacuum packing machine

Writer: admin Time:2021-04-08 16:06 Browse:

1. Switch on the power supply and flip the power selection switch according to the need, that is, the power indicator is on.Power selector switch pointing vacuum is vacuum sealing, pointing vacuum charging is vacuum filling sealing.

 

2. Put the plastic bag with articles in the vacuum chamber, and put the mouth of the bag neatly on the heat seal (if it is used as inflatable packaging, there should be at least one nozzle inserted into the mouth of the bag).

 

3. Press down the cover, and the exhaust (vacuum) indicator light on the panel is on.When the vacuum pump starts pumping, the cover is automatically sucked. The vacuum knob can adjust the vacuum degree according to the packaging requirements. When adjusting, the range should be small according to the scale from low to high.

 

4. Bag the products that need vacuum packing, then put the open end on the sealing strip and keep the bag straight. If it is a small bag, you can pack multiple bags side by side at the same time.

 

Vacuum packing machine

 

5. When the exhaust reaches the set time (that is, the required vacuum degree), the exhaust is over, the exhaust indicator light is off, and the inflating indicator light is on, indicating the inflating begins.The inflating knob can adjust the inflating time (that is, the amount of inflating). The method is the same as above.If it is not necessary to inflate, turn the power switch to the vacuum position, the program will automatically enter the vacuum package, and the inflating indicator light will go off.

 

6. When the air is pumped or inflated, the indicator light will go out and the heat sealing indicator light will light up, and then the sealing procedure will be entered. The panel is equipped with a heat sealing time and temperature adjusting knob to adapt to different thickness materials.

 

7. When the set heat sealing time is reached, the heat sealing indicator light goes out, and the heat sealing ends as seen, that is, the vacuum chamber enters the atmosphere through the solenoid valve, until the cover is automatically lifted, the vacuum filling packaging process is finished, and the next packaging cycle is ready.

 

The above is the introduction of the technological process of automatic vacuum packing machine. Is everyone clear?I believe that through the description of this article, you can have a certain understanding of the packaging machine, I hope this article can help you.In addition, if you want to learn more about the relevant information, you can pay more attention to our website.

CONTACT US

QQ: 2822032484

Phone: 16552836888

Tel: 165-5283-6888

Email: 15266307184@163.com

Add: 10047 Xinxing Road, Xinxing Town, Zhucheng City, Shandong Province, China

Scan the qr codeClose
the qr code